Bosch AE115 Manuel d'utilisateur

BoschBoschThermotechnology Corp.340 Mad River Park,Waitsfield, VT 05673Telephone866-642-3199 Thermotechnology Corp.

Diagram 4: Internal wiring schematic for single phase AE125 unit. (AE115 does not have Elt 5 & 6 fitted and uses two supplies). (In Canada

Spare Parts Part Number Description (Refer to Diagram 1, Page 4) 93 793770 4 way term. block (for AE115) 93 793771 6 way term. block (for AE125)

Troubleshooting WARNING Always switch off the electricity supply to the unit before you remove the cover. IMPORTANT: If you are unable to perform

Water too cold – Neon light on Temperature dial is turned too low Turn the temperature dial located on the bottom of the water heater

Using an Ohmmeter to check for Premature element failure LEFT MODULE Top View RIGHT MODULE Top View Meter probes Ohm

Water Temperature Too Hot Temperature dial set too high Turn the temperature knob located on the bottom of the water heater counterclockwise for co

(…Continued) comparable model. However, if the water heater is installed in other than a single family dwelling thisheating modules warranty is limi

Important Safety Instructions When using this electrical equipment, basic safety precautions should always be followed, including the following: 1.

Specifications AE115 Unit AE125 Unit Voltage supply 2 x 240V AC (Canada 240VAC) 3 x 240V AC (Canada 240VAC) Amperage 2 x 40 A (Canada 80 A) 3

Mounting the Powerstar WARNING: The heater must only be installed in the orientation shown in Diagram 1 i.e., mounted in a vertical position with th

• Do not use plastic piping within 3 feet on either side of heater. • Use Teflon tape for sealing pipe threads. Do NOT use pipe dope. • Remembe

Diagram 2 AE115 Terminal Block Connection The AE115 requires two independent 240V AC circuits protected by two separate and independent double pol

Canada wiring – auxiliary terminal block and connections Fitting the auxiliary terminal block (see diagram below). AE115

Starting up the PowerStar Checking for leaks and purging air • Verify all circuit breakers supplying power to the water heater are turned off. •

For example: • For the AE115 unit, using the outlet ball valve, ensure the flow rate does not exceed 2.3 gallons / minute. • For t