Bosch SE2005 Guide d'installation télécharger pdf (Page 25)

Security Escort | Installation and Setup Guide | 3.0

Installation Instructions

EN | 25

Bosch Security Systems | 1/09 | 33831E

3.0 Installation

Instructions

3.1 Overview of Installation

Process

This section includes information

about the installation and setup of

the individual components and system

wiring. It is recommended that the

installation instructions that

accompany each specific component be

consulted prior to beginning any phase

of the installation.

A typical installation proceeds in the

following order:

1. The Site Survey is completed,

indicating the proposed location of

each component.

2. Wiring runs to all of the proposed

component locations and the central

console.

3. Empty enclosures are installed as

specified in the Site Survey.

4. The components are secured inside

the enclosures and connected to the

previously run wiring.

The individual components are set up

and their addresses recorded.

Note:

Use the Transponder Information

Sheet, located in the Appendix of

this document, to keep track of

receiver and alert unit addresses

and location for programming the

Transponder Database.

5. The recorded addresses are entered

into the central console and the

system is brought on-line.

6. The system is tested and tuned up

as needed.

3.2 Run System Wiring

3.2.1 General Guidelines

After the site survey and special pre-

construction verifications are

completed, the wiring can be run

between the proposed locations of the

system components and the central

console. See specific installation

instructions accompanying each

component for wiring details.

Table 6

indicates the specifications for the

wiring.

Table 6: Wiring Guidelines

Application

From To

Diagram

Reference* Gauge

Conductor

Maximum

Distance Notes

Transponde

Transforme

1 1.5 mm

(16 AWG)

2 15 m

(50 ft.)

Standard lamp

cord

Alert unit 2 1.2 mm

(18 AWG)

4 900 m

(3000 ft.)

per bus

Solid, not

twisted, not

shielded

Receiver 2 1.2 mm

(18 AWG)

4 900 m

(3000 ft.)

per bus

Solid, not

twisted, not

shielded

SE485 3 0.5 mm

(24 AWG)

4 wire, 2

twisted

pair

See Table

IMPORTANT!

Must be

twisted pair,

not shielded.

CAT 5 cable

preferred

Siren/stro

4 1.2 mm

(18 AWG)

4 15 m

(50 ft.)

Solid, not

twisted, not

shielded

Alert Unit Transforme

5 1.5 mm

(16 AWG)

2 15 m

(50 ft.)

Standard lamp

cord

Alert Unit Siren/stro

6 1.5 mm

(18 AWG)

4 15 m

(50 ft.)

Solid, not

twisted, not

shielded

* See the corresponding numbers in Figure 5, Figure 6, and Figure 7.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Bosch SE2005 Guide d'installation Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Bosch SE2005