Bosch LBB 1925 Instructions d'exploitation Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 30
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Bosch Security Systems | 2003-09 | 3922 988 99483en
Plena System Pre-amplifier | Installation and Operating Manual | en | 11
2.5 Setting single and dual channel use
The system pre-amplifier can be used with one booster amplifier for both music and calls ('1 channel use'). Any call
will interrupt background music in all zones. It is also possible to use separate booster amplifiers, for music and calls
('2 channel use'). Now a call will not interrupt music in zones, not addressed by the call. Jumper JP102 selects
whether background music is going to the Master output (1 channel use) or not (2 channel use). Jumper J2 must be
set to either 1 channel use or 2 channel use to select the amplifier terminals for the zones.
2.6 Override contact setting
Jumpers J3 and J4 select whether the override output for each zone (indicated by ) is switching between the 0V
and 100V loudspeaker signal, or between ground and 24Vdc. This override output is available per zone and may be
used to override local volume controls, to make sure that calls are coming through. For 3-wire volume override, the
jumpers should be in 100V audio position. For 4-wire override the jumpers should be in 24Vdc position. The
drawings show the principle of 3- and 4-wire volume override. The override outputs are activated whenever a call is
made, when the emergency input is activated, or an alarm or time signal is triggered. At the same time also the Call
Active relay is activated, providing a potential free contact.
D614
RL606 D613
RL605 RL604 RL603 RL602 RL601
RL611RL612
J4
J3
CN21
Override
24V dc
10 0 V
audio
CN24
RL610
RL611RL612 RL610 RL609
25-6
3938 101 90272
RL608 RL607
CN22 CN20
RL609
D605D606 D604 D603
RL608
D602
RL607
D601
CN3
LOCA L VOLUM E
CONTROL
OVERRIDE
AMPLIFIER
3-wire (zone 1-6)
0V
100V
LO CAL VOLUME CONTROL
OVERRIDE
AMPLIFIER
4-wire (zone 1-6)
0V
100V
24V
DC Out 24V (-)
Figure 2.5
Figure 2.4 Figure 2.6
Internal settings
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Commentaires sur ces manuels

Pas de commentaire