Bosch DS7400XiV4-EXP Manuel d'utilisateur télécharger pdf (Page 27)

DS7400XiV4-EXP | User Guide | 10.0 Testing Your System EN | 27

Bosch Security Systems | 6/05 | 4998154961B

10.0 Testing Your System

10.1 Zone Test

The zone test confirms that detectors report alarms to the keypad. A zone test works on all zones, except 24-hour

zones and fire zones. While the keypad is in a zone test, no control panel alarms activate an alarm, except 24-hour

zone alarms and fire alarms; these alarms override the zone test function.

This test requires you to manually alarm each zone.

At the start of the test, if programmed, a report is sent to the central station followed by reports on the individual

zones as they are tested. When the zone test is complete, a test restoral report is sent to the central station.

If you perform this test from a Master Keypad, the keypad must be in Single Partition Mode. Zone tests are not

available from RF (wireless) keypads.

Test the system weekly.

Table 25: Zone Test

Type of Test Command Sequence What Happens What To Do

Zone Test [PIN][#][8][1] • “Test Zone” is displayed followed by the

numbers of the zones that were not tested. *

• The zone LEDs of any untested zones flash. **

• “Now Testing” is displayed followed by the

number of the zone currently being tested. *

• The LED for the zone currently being tested

turns on steady. **

• As each zone is tested, “Test Zone” appears

followed by the remaining untested zones. *

• As each zone is tested, its LED turns off. **

• Test each zone as

instructed by your

installing company.

• Exit the Zone Test using

[PIN][#].

* Text Keypad only

** LED Keypad only

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Pas de commentaire

Bosch DS7400XiV4-EXP Manuel d'utilisateur Page 27