D1260
Overview
D1260 Installation Guide
© 2003 Bosch Security Systems Page 9 48101D
2.2.3 Command Center Function Keys
Key Picture Description
Command Use the [COMMAND] key in combination with one or
two numeric keys to perform a function.
ENTER Use the [ENTER] key to complete the entry of your
passcode at the command center.
The D1260 has ten numeric
keys, two dedicated keys (see
Table 5) and 8 soft keys (see
Section 2.2.3.1 Soft Keys),
that are used to control your
system.
Table 5: D1260 Command Center Function Keys
2.2.3.1 Soft Keys
There are eight “soft” keys (four on either side of the display) for
accessing menu functions, among other items.
When a selection is available, an arrow (< or >) is displayed next to
the key. To select the function, simply press the key next to it.
Figure 4: D1260 Soft Keys
2.2.4 Audible Tones
Tone Description
Fire Signal When an area is in fire alarm, the D1260 emits a pulsed,
high-pitched “bell” tone.
Burglary Signal When an area is in alarm, the D1260 emits a steady, high-
pitched “bell” tone.
Entrance Warning The D1260 emits an intermittent beep tone during entry
delay periods to remind the user to disarm the area. This is
a programmable option.
Exit Warning The D1260 emits an intermittent beep tone during exit
delay and counts down the number of seconds left until
arming takes place. This is a programmable option.
Invalid Key Buzz When an invalid key, or sequence of keys, is pressed, the
D1260 emits a flat buzz tone.
Keypad Encoding
Tone
The D1260 emits a muted beep tone as each key is pressed
to indicate that the entry has been accepted. To disable this
feature see Section 3.2 Setting the DIP Switch on page 12.
Trouble Buzzer When a trouble event occurs, such as a service alert, the
D1260 emits a two-tone warble until you enter
[COMMAND] + [4].
Watch Tone When you activate the Watch feature ([Command] + [6]),
a single clean tweedle tone alerts the user anytime a watch
point is faulted. This option is programmable by point. To
disable the Watch Feature, press [Command] + [6] again.
The D1260 Command Center has
a built-in speaker that produces
several distinct warning tones.
The speaker volume and display
brightness required can be
changed to meet the individual
needs of the user. You cannot
connect external annunciation
devices to the D1260. Anytime an
audible tone is emitted from the
D1260, the command center
backlight will illuminate.
The signals in Table 6 are silenced
by entering a programmed
passcode with the appropriate
authority, or [COMMAND] + [4]
unless otherwise noted.
Table 6: Audible Tones
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels