Bosch D1260 Series Guide d'installation télécharger pdf (Page 11)

D1260

Installation

D1260 Installation Guide

3.0 Installation

3.1 Mounting

The D1260 Command Center is a low profile, surface-mounted unit. It can also be mounted using the following optional

packages:

• D56 Command Center Keypad Conduit Box - Protected surface mount or flush mount

• D55 Command Center Desk Stand – Desktop

• D54B-1260 Command Center Flush Mount Kit (Brass)

• D54C-1260 Command Center Flush Mount Kit (Stainless)

3.1.1 Location Recommendations

• Do not mount the command center in a location where it will be exposed to direct sunlight. Direct sunlight

can interfere with the D1260 display screen visibility and damage internal components.

• Do not mount the D1260 in wet or moist locations.

3.1.2 Mounting the Backplate

The backplate for the D1260 keypad has a variety of

mounting holes to accommodate different mounting

standards.

1. Standard 3-point mounting

2. Single-gang electrical box

3. Dual-gang electrical box

4. Triple-gang electrical box

Figure 6: D1260 Backplate Mounting Options

To correctly mount the backplate, follow the steps below:

1. Remove the backplate from the D1260 by using a flat-blade

screwdriver to press the two small tabs on the bottom of the D1260.

2. Lift away the D1260 from the backplate.

3. Ensure that the backplate is right-side up.

4. Line up the mounting holes with the desired mounting method

(Standard 3-point, Single, Dual, or Triple-gang electrical boxes).

5. Feed the 4-wire flying lead (from the panel) through one of the square holes at the bottom of the

mounting plate.

6. Insert and tighten screws through the appropriate mounting holes to secure the mounting plate to the

wall.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Bosch D1260 Series Guide d'installation Page 11