Bosch HBL8742UC Manuel d'installation télécharger pdf (Page 8)

Removing Packaging

Cut straps on the outside of the boxes.

Remove the upper boxed unit of the combination oven

and place on floor so that both shipping cartons can

be opened.

Perform the following steps on both units of the

combination oven.

▯ Remove the cardboard box by lifting it up and off

the unit

▯ Remove all top and side cardboard and foam

braces.

▯ Place the unit (leaving it on the shipping base) in

front of the cabinet where it is to be installed.

▯ Remove all accessories, racks, packing materials

and literature from the oven cavities.

▯ Unscrew unit from packaging brackets as shown in

“Packaging Bracket Removal-Left and Right Sides”.

Notes

▯ The screws near the base mounting bracket of each

unit are all Star-head (T-20 size). Only the one screw

that goes through the slotted hole in the mounting

bracket on the left and right sides of the unit needs

to be removed in order to lift the unit from the

mounting base. The screw circled in the image

below and marked as (A) is the screw that needs to

be removed.

▯ Remove one screw only from each bracket. This will

release the oven from the shipping base. Do not

remove any additional screws from the oven.

Packaging Bracket Removal-Left and

Right Sides

Note: Actual bracket varies in appearance. The bracket

remains in the packaging base. The unit should stay on

the packaging base until ready to be lifted into cabinet

cutout or onto the lower oven.

Preparing Ovens

Place ovens in front of the cabinet where it is to be

installed so that they are in line with the cabinet cutout.

Check to be sure all packing materials have been

removed from the unit. Also remove the accessories,

oven racks, literature pack and any shipping materials

from inside the oven cavity. Check both ovens for a

double oven or combination oven installation.

Installation

Pre-Assembly of the Combination Oven

Combination ovens require the two components to be

assembled prior to installing the combination unit into the

wall cabinet.

Note: The installation procedures differ between the

microwave, speed oven and steam convection oven

combination units. The parts contained in the square

tube parts box are common to all three installations.

Parts Provided

Universal connector

bracket (2)--in parts box

on top of oven

Screws (16)--in red bag

inside parts box on top of

oven.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Bosch HBL8742UC Manuel d'installation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Non Bosch HBL8742UC