Bosch VOT-320V009L Manuel d'utilisateur télécharger pdf (Page 19)

Bosch Sicherheitssysteme GmbH Installation and Operating Manual

Doc | V4.6 | 2014.02

VOT-320 Installation | en 19



4.3

Connections



Network

You can connect the VOT-320 to a 10/100 Base-T network using a standard UTP category 5

cable with RJ45 plugs.



Pin EIA/TIA-568-A EIA/TIA-568-B

1 white/green white/orange

2 green orange

3 white/orange white/green

4 blue blue

5 white/blue white/blue

6 orange green

7 white/brown white/brown

8 brown brown



1. First crimp the wires according to the EIA/TIA standard you are using.

2. Connect the VOT-320 to the network via the RJ45 socket on the back of the camera

module.



Data interface

The bidirectional data interface is used to control units connected to the VOT-320, such as

pan/tilts that are not connected directly to the P/T connections (see Section Pan/tilt

connection, page 20). The connection supports the RS-232, RS-422 and RS-485 transmission

standards.

The VOT-320 offers the serial interface via the upper 6-pin terminal block (see

Section 8.8 Terminal blocks, page 99).

The range of controllable equipment is expanding constantly. The manufacturers of the

relevant equipment provide specific information on installation and control.

CAUTION!

Please take note of the appropriate documentation when installing and operating the unit to

be controlled.

The documentation contains important safety instructions and information about permitted

uses.



NOTICE!

A video connection is necessary to transmit transparent data.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 115 116

Pas de commentaire

Bosch VOT-320V009L Manuel d'utilisateur Page 19