Bosch D720 Manuel d'utilisateur télécharger pdf (Page 10)

Turn the Entire System On With Delays

 I have this feature.

 I do not have this feature.

 This feature requires a passcode.

Command 1 is used to arm the entire system, both perimeter and interior points.

Once you enter Command1, the exit delay time starts. You now have a

predetermined amount of time to exit the protected area before the system arms.

During the exit period, you can move through motion detectors or any protected area

on your way to any exit without causing an alarm. To cancel Command 1, enter

your personal passcode and press [ENT].

Note: If you leave the building after the exit time expires, you can begin the entry

delay or initiate an alarm. It this happens, disarm your system by entering

your personal passcode and press [ENT]. It your system reports to a central

station, call them if an alarm occurs.

Application

Command1 is useful in applications where you want your cleaning or service

personnel, or anyone else to arm your system when they leave, but you do not

want them to have the passcode to disarm the system. Command 1 arms the

system, but does not disarm the system.

COMMAND 1

Arming with COMMAND 1:

1. Ensure all points are secure. All of the Point Status indicator

lights on the Keypad should be off. If not, refer to Force Arming

the System on page 29.

2. Press the [COMMAND] bar. The Command mode indicator light

comes on.

3. Press the [1] key. The PERIMETER indicator and the INTERIOR

indicator lights begin to flash on and off, showing the system has

begun exit delay time.

4. To disarm your security system or cancel COMMAND 1, enter your

personal passcode and press [ENT] before the delay time expires.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Bosch D720 Manuel d'utilisateur Page 10