Bosch D720 Guide de l'utilisateur télécharger pdf (Page 21)

Fire Test

 I have this feature.

 I do not have this feature.

 This feature requires a passcode.

Use this function to test points and other 24-hour points to be certain they

function properly. You can review untested points at your keypad to help

pinpoint any problems.

When initiated, the Fire Test tests the fire bell pattern on the bell output and rings

the keypad fire bell for 2 seconds. The AC is disabled for 4 minutes to test the

system’s battery power. If the battery cannot maintain the system for the 4-minute

period, the keypad appears to go dead. If this happens, contact your security

company. At the end of the 4-minute period, AC returns to the system and the

control panel restores. A message is be sent to your security company upon

initiation and completion of the Fire Test. During the Fire Test, no 24-hour alarms

are sent to your security company.

If there is no activity on the system for 20 minutes, the system automatically exits

from the Fire Test.

COMMAND 5 8

To use Fire Test:

1. Ensure your security system is idle.

2. Press the [COMMAND] bar. The Command mode indicator light

comes on.

3. Press the [5] key, and then the [8] key. Audible devices (both interior

and exterior) sound the fire bell.

4. One by one, activate the detection devices to fault each point. The

audible fire devices sound momentarily and the keypad display

indicates the faulted point, verifying that the detection device is

working properly.

5. To end the Fire Test, press any numeric key on the keypad. If no

activity occurs on the system for 20 minutes, the fire test ends

automatically.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Pas de commentaire

Bosch D720 Guide de l'utilisateur Page 21