Bosch D720 Guide de l'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
Function Keys
The keypad has three function keys (labeled A, B, and C). The function keys are
used to perform system commands with the touch of one key. Your alarm
technician programs the Function Keys.
Function Key Function Performed
[A] ______________________________
______________________________
[B] ______________________________
______________________________
[C] ______________________________
______________________________
Note: The [A], [B], and [C] keys can perform various functions. These functions
require a few seconds before they are completed, because the system is
completing several instructions at once. Therefore, please wait for 5 seconds
after using the [A], [B], or [C] keys to allow the system to “catch up.
Turning the System On (Arming)
Your security system is turned on (armed) in many different ways, depending on
the arming command used. Arming commands turn the system on. The most
basic arming command is to arm the entire system. The simplest way to arm your
system is to enter your personal passcode and press [ENT] or to use COMMAND
1.
There are several other arming commands to turn the system on. For example:
arm only the perimeter or arm only portions of the perimeter. These arming
functions and their respective commands are described later in this guide.
Turning the System Off (Disarming)
Your security system is turned off by entering your personal passcode and
pressing [ENT]. When your system is turned on, you must enter the premises
through a designated entry door to prevent an immediate instant alarm
condition. Open the door starts an entry delay time and the keypad emits a
pulsing beep tone to remind you to turn the system off. Enter your personal
passcode and press [ENT] before the delay time expires and the system turns off.
If you enter through a wrong door or fail to disarm before the entry delay
expires, causes an alarm. If this happens, silence the alarm (by entering your
personal passcode and pressing [ENT]) and call your security company to notify
them it is not an emergency situation.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Commentaires sur ces manuels

Pas de commentaire