Bosch DIW116750 Manuel d'installation télécharger pdf (Page 26)

26

Prior to installation

Preparing the ceiling

❑

The ceiling must be ﬂat and horizontal.

❑

Ensure that the ceiling is capable of pro-

viding a ﬁrm hold for mounting screws

and plugs. The enclosed plugs are sui-

table for concrete and stonework.If the

ceiling is made of any other material,

use appropriate mounting components.

Changing over from exhaust-

air to recirculating mode

Changing the electronic control system

to recirculating mode:

❑

The electronic control system has been

set up in the factory for the mode

applicable to the extractor hood version

which you have purchased.

❑

If it becomes necessary to change the

mode, the electronic control system

must also be changed over.

Weight in kg:

Exhaust air Recirculating air

37,0 39,0

We reserve the right to construction changes within the

context of technical development.

Change-over procedure:

❑

The extractor hood must have been

connected up and should be switched off.

1. Press and hold the 0 button.

2. While { is displayed, press the

button until

ã or # is displayed. When this

has taken place, release the buttons.

Changing from exhaust-air to

recirculating mode:

❑

ã goes out shortly afterwards.

The electronic control system will then

have been set to recirculating mode.

Changing from recirculating to

exhaust-air mode:

❑

# goes out shortly afterwards.

The electronic control system will then

have been set to exhaust-air mode.

Electrical connection

WARNING: THIS APPLIANCE MUST BE

EARTHED

IMPORTANT: Fitting a Different Plug:

The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow – Earth

Blue – Neutral

Brown – Live

If you ﬁt your own plug, the colours of

these wires may not correspond with the

identifying marks on the plug terminals.

This is what you have to do:

1. Connect the green and yellow (Earth)

wire to the terminal in the plug marked

‘E’ or with the symbol ( ), or

coloured green or green and yellow.

2. Connect the blue (Neutral) wire to the

terminal in the plug marked ‘N’ or

coloured black.

3. Connect the brown (Live) wire to the

terminal marked ‘L’, or coloured red.

The extractor hood should only be

connected to an earthed socket that has

been installed according to relevant

regulations.

If possible, site the earthed socket directly

above the chimney panelling in the ceiling.

 Before undertaking any repairs,

always disconnect the extractor hood from

the electricity supply.

Length of the connecting cable: 1.30 m.

In order to replace the mains cable, it is

necessary to dismantle the pipe

connection piece (undo two screws).

If it is necessary to wire the extractor

hood directly into the mains:

The extractor hood should only be

connected to the electricity supply by a

properly qualiﬁed electrician.

A separator must be installed in the

household circuit. A suitable separator is a

switch that has a contact gap of more than

3 mm and interrupts all poles. Such

devices include circuit breakers and

contactors.

This extractor hood corresponds to EC

regulations concerning RF interference

suppression.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 99 100

Commentaires sur ces manuels

Pas de commentaire