Bosch NTC-265-PI Manuel d'installation télécharger pdf (Page 15)

IP Camera 200 Series Installation | en 15

Bosch Security Systems Installation Manual AM18-Q0610 | v1 | 2012.02

3.4 Power connection

The camera can accept power from both the DC12V power

input and the Ethernet input at the same time. You can remove

either one of the power sources without interrupting camera

operation.

3.4.1 DC power connection

Figure 3.3 DC power connection

Connect power from a 12 VDC class 2 power supply as follows:

1. Use AWG22 wire; cut back 5 mm (0.2 in) of insulation.

2. Remove the 2-pole connector from the camera cable tree.

3. Loosen the screws and insert the wires.

4. Tighten the screws and reconnect the 2-pole connector to

the power connector of the camera cable tree.

5 mm

(0.2 in)

12 VDC

22AWG

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Bosch NTC-265-PI Manuel d'installation Page 15