Bosch B450 Spécifications télécharger pdf (Page 12)

Figure 4.3: Mounting the module to the exterior wall of the enclosure

Callout ￚ Description

1 ￚ B450

2 ￚ Enclosure (outside wall shown)

3 ￚ Mounting screws (3 screws included)

Installing in a control panel enclosure

Install the B450 on the inside enclosure wall that also contains the supported control panel.

The control panel powers the B450 via the terminal block or bus connection.

Installing in a separate enclosure

Install the B450 on the inside wall of a separate enclosure. The control panel in a nearby,

separate enclosure powers the B450 via the terminal block or bus connection.

Installing in a separate enclosure with separate power supply

Install the B450 on the inside wall of a separate enclosure that also has a separate external

power supply such as the B520 Auxiliary Power Supply Module.

Mount and wire the tamper switch (option for SDI2 bus only)

You can connect an enclosure door tamper switch for one module in an enclosure.

Installing the optional tamper switch for use with a B450:

1. Mount the tamper switch into the enclosure’s tamper switch mounting location.

2. Plug the tamper switch wire onto the module’s tamper switch connector. For the tamper

switch connector location, refer to Module overview, page 7.

3. Verify the B450 module is configured with tamper enabled ON within the SDI2 supported

control panel. Tamper is automatically enabled to ON in GV4 Series v2.00 control panels.

Install and mount the plug-in communicator antenna

Perform the following steps below to install and mount the magnetic antenna.

4.3.1

4.4

12 en | Installation

Conettix Plug-in Communicator

Interface

2013.09 | 02 | F.01U.282.875 Installation and Operation Guide Bosch Security Systems, Inc.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Pas de commentaire

Bosch B450 Spécifications Page 12