Bosch D1265 Guide d'installation télécharger pdf (Page 12)

12 en | Programming the Control Panel for Common Reporting Options D9412GV4/D7412GV4/D7212GV4

F01U215242 | 01 | 2011.10 Quick Reference Guide Bosch Security Systems, Inc.

5 Programming the Control Panel for Common

Reporting Options

5.1 Set Up Daily Test Report Using RPS

1. Go to SCHEDULES→Skeds.

2. Enter Function Code 9 (Test Report) in an unused Sked.

3. Select NO for the Deferred parameter to send test reports regardless of other test

reports sending between scheduled test reports.

4. Select NO for the Hourly parameter to send test reports only when the sked executes and

not every hour.

5. Enter the time at which you wish the schedule to send the report.

6. Leave the Date parameter disabled so that the sked executes by days of the week instead

of only on a selected date.

7. Select YES for each day of the week.

8. Select NO for:

– Except On Holiday

–Holidays 1 - 4

5.2 Set Up Open and Close Reports Using RPS

5.2.1 Area Wide Parameters

To report each area independently:

–Go to AREA WIDE PARAMETERS→Area/Bell,Open/Close Options→Acct Open/Close in

RPS. Select NO (default).

–Go to Area Open/Close in RPS). Select YES (default).

To report by account (Close signal is sent when the last area in an account is armed; Open

signal is sent when the first area is disarmed):

– Go to AREA WIDE PARAMETERS→Area/Bell,Open/Close Options→Acct Open/Close

in RPS. Select YES.

– Go to Area Open/Close in RPS. Select NO.

5.2.2 Set Authority Level

1. Go to USER INTERFACE→Authority Levels.

2. Go to the Authority Level to be used by users sending Open and Close reports.

3. Select E (enabled) for Area Open/Close.

4. Select E for Restricted Open/Close.

5. Select E for Perimeter Open/Close.

NOTICE!

If you want Perimeter Open and Close, select Perimeter O/C = YES.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Bosch D1265 Guide d'installation Page 12