Bosch PCS815B90Y Manuel d'instructions télécharger pdf (Page 13)

Hob frame

In order to avoid damage to the hob frame, follow the

indications below:

■ Use only slightly soapy hot water

■ Do not use sharp or abrasive products

■ Do not use a glass scraper

Cleaning the control panel

Use only slightly soapy hot water. Do not use abrasive or

corrosive cleaning products. Do not use glass scrapers. The

control panel could be damaged.

Lemon and vinegar are not suitable for cleaning the control

panel. Dull stains may appear.

Control discs

It is recommended that the control discs are only cleaned using

hot water with a little soap. Do not use abrasive or corrosive

cleaning products. Do not wash the control disks in a

dishwasher.

Fixing malfunctions

Malfunctions are generally caused by minor faults. Before

contacting the Technical Assistance Service, make sure you

have read the following recommendations and warnings.

Indicator Malfunction Measure

none The electric power supply has been inter-

rupted.

Use other electrical appliances to check if there has been a power

cut.

The appliance has not been correctly con-

nected following the connection diagram.

Make sure that the appliance has been connected correctly.

Electronic system malfunction. If in the above checks, the malfunction is not resolved, contact the

Technical Assistance Service.

“ flashing

The control panel is wet or an object is

resting on it.

Dry the control panel area or remove the object.

“§ + number /

š + number /

¡ + number

Electronic system malfunction. Disconnect the hob from the mains. Wait 30 seconds or so, then con-

nect it again.*

”‹ / ”Š

There is an internal error in the system. Disconnect the hob from the mains. Wait 30 seconds or so, then con-

nect it again.*

”ƒ

The electronic system has overheated and

the corresponding hotplate has been

switched off.

Wait until the electronic system has cooled down completely. Then

press any symbol on the hob.*

”…

The electronic system has overheated and

all hotplates have been switched off.

—‚

Supply voltage outside normal operating

limits.

Please contact the local electricity board.

—ƒ / —„

The hotplate has overheated and switched

off to protect its working surface.

Wait until the electronic system has cooled down sufficiently before

switching it back on.

* If the warning persists call the Technical Assistance Service.

Do not place hot pans on the control panel.

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Bosch PCS815B90Y Manuel d'instructions Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Bosch PCS815B90Y