Bosch SHXM63W55N Manuel d'installation télécharger pdf (Page 23)

WARNING

NOTICE

Avoid Scald Hazard

Do not perform any work on a charged hot water line. Serious injury

could result. Only qualied plumbers should perform plumbing work.

Do not attempt any work on the dishwasher hot water supply plumb-

ing until you are certain the hot water supply is shut off.

Temperatures required for soldering and sweating will damage the

dishwasher. If plumbing lines are to be soldered or sweated, keep the

heat source at least 6 inches (152.4 mm) away from the dishwasher.

Hot Water Supply

The hot water heater should be set to deliver approximately 120° F (49° C)

water to the dishwasher. Water that is too hot can cause some detergents

to lose effectiveness. Lower water temperatures will increase run times.

The hot water supply pressure must be between 15 - 145 psi (1 - 10 bar).

IMPORTANT NOTES:

• If using a solder joint instead of a compression fitting, be sure to make

all solder connections before connecting the water supply line to the

dishwasher.

• Make sure there are no sharp bends or kinks in the water line that might

restrict water flo .

• Always use the appropriate seal when making plumbing connections.

• Before connecting the water supply line to the dishwasher, flush the

incoming water line for approximately 5 minutes to clear any foreign

material.

• Turn on the water supply and check for leaks after connections are

made.

Water Inlet Connections

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 87 88

Pas de commentaire

Bosch SHXM63W55N Manuel d'installation Page 23