Bosch NETP666SUC Manuel d'utilisateur télécharger pdf (Page 21)

Error messages

Notes

▯ The cooktop regulates the heating element

temperature by turning the heat source on and off; this

means that the reddish glow of the heat source

beneath the heating element may not always be

visible. If you select a low heat setting, the heat source

is frequently off; at higher settings it is seldom off. The

source turns on and off even at the highest settings.

▯ You may hear a quiet hum when the heating elements

are in the heating phase. The heating elements may

glow with different levels of brightness. Depending on

the angle from which you are looking at the heating

element, this glow may be visible over the marked

edge of the heating element. These are technical

characteristics. They have no effect on quality and

function.

▯ Glass ceramic may have uneven areas on the surface

due to the nature of the material itself. Because of the

mirror-like finish on the cooking surface, even

extremely small bubbles less than 1 mm in diameter

may be visible. These bubbles will not have any

adverse effect on the operation of the cooktop nor on

the durability of the glass ceramic cooking surface.

▯ Depending on the countertop that is present in the

kitchen, an uneven gap between the cooktop unit and

the countertop can occur. For this reason, a flexible

seal is provided around the entire cooktop unit.

Technical service

Contact our Technical Service Department if your

appliance needs repair. Our central Customer Service

Center (see below) will also be happy to supply you with

details on a center close to you.

E number and FD number:

When you contact our service, please have the Model(E)

number and the FD number for your appliance available.

You can find the identification plate with these numbers

on the underside of the appliance and in the appliance

booklet.

Questions? Please contact us. We look forward to

hearing from you!

Display “ and numbers

A fault in the electronic system has

occurred.

Turn the appliance off and back on at the fuse or cir-

cuit breaker. If the same fault occurs again, disconnect

the appliance and call Technical Assistance Service.

Display ” and numbers

A fault has been detected. The following table of error messages lists actions you

can take to correct the problem

Display Fault Measure

”ƒ

The element is too hot and has

turned off.

Remove the pans from the elements. ”ƒ disappears

when you press the display, if the element has cooled

down sufficiently. Wait a few minutes until the element

has cooled down a bit. If ”ƒ appears again after the

element is turned back on, the cooktop is still too hot.

Turn off the elements and allow them to cool further.

”…

The touch control zone is too hot. Make sure that cookware is properly positioned on the

element, and no hot objects are in contact with the

touch control zone. Wait a few minutes until the touch

control zone has cooled down. If

”… appears after you

turn on the appliance, call Technical Assistance Ser-

vice.

”ˆ

AutoChef™ is defective. Confirm and close the error message by touching any

area on the touch control zone. You can cook without

AutoChef™. Contact Technical Assistance Service.

”‰

The element was in continuous use

for too long.

The automatic time limitation has been activated.

Touch any key. You can now turn on the heating ele-

ment immediately.

0DLQ6WUHHW6XLWH

,UYLQH&$

ZZZERVFKKRPHFRP



1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Bosch NETP666SUC Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Bosch NETP666SUC