Bosch SM024 Manuel d'installation télécharger pdf (Page 12)

12 | Wiring Diagram Replacement/Data Plate Placement SM Series Electric Heat

SM Series Electric Heat8 733 904 449 (2013/04) Subject to change without prior notice

WIRING DIAGRAM REPLACEMENT/

DATA PLATE PLACEMENT

1. Remove the wiring diagram that is adhered to

the back side of the front panel. Replace with

the wiring diagram that was included with the

heater kit. Using spray adhesive glue is

recommended. See Figure #36

Figure # 36

2. Place the adhesive backed heater data label

above existing dataplate label.

UNIT START UP

1. Turn the disconnect switch or breaker switch

to the “ON” position for the compressor and

for the new separate circuit servicing the

blower motor and the heating elements.

2. Run the unit in heating mode with the heating

elements engaged for at least 10 minutes to

ensure the unit does not shut down due to any

temperature limiting device.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Bosch SM024 Manuel d'installation Page 12