Bosch SGE68X55UC Instructions d'exploitation télécharger pdf (Page 31)

Operating the Dishwasher en-us

31

AquaSensor

The AquaSensor is an optical

measuring device which measures

the cleanliness of the rinse water.

The AquaSensor is used according

to the wash cycle. If the AquaSensor

is active, “clean” rinse water can be

transferred to the next rinse and

water consumption can be reduced

by 0.8–1-5 gal (3–6 liters). If the

rinse water is not yet clear, the water

is drained and is replaced with fresh

water. In the automatic wash cycles

the temperature and running time

can also be adjusted to the degree of

soiling.

Switching the appliance on

1.

Turn the water supply on fully.

2.

Press the On/Off button (.

The AUTO wash cycle has been

preset as a default whenever the

appliance starts. This wash cycle

remains selected if no other wash

cycle button 0 is pressed.

Select any desired option.

3.

Press Start button P.

Wash cycle sequence starts.

Note: Your dishwasher is protected

against unintentional operation. If the

appliance door remains open for

more than 4 seconds after pressing

the Start button, the operation will be

paused. Close the appliance door

and press the Start button P again.

Time display

When a wash cycle is selected the

remaining wash cycle time is shown

on the display 8.

The wash cycle time is determined

during the wash cycle by the water

temperature, the amount of dishes,

as well as the degree of soiling and

may vary (depending on the selected

wash cycle).

Delay start

You can delay the start of the cycle in

one hour increments up to 24 hours.

To set Delay start:

1.

Press On/Off button (. Select a

cycle.

2.

Press Delay button @ until the

displayed time corresponds with

your requirements.

3.

Press Start button P to activate

Delay start.

To cancel Delay start:

1.

Press Delay button @ until œ:‹‹

is indicated on the digital

display 8.

2.

Press Start button P to save

setting.

Note: Your dishwasher is protected

against unintentional operation. If the

appliance door remains open for

more than 4 seconds after pressing

the Start button, the operation will be

paused. Close the appliance door

and press the Start button P again.

œ:‹‚ 1 hour delay

œ:ƒ… 24 hours delay

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 107 108

Commentaires sur ces manuels

Pas de commentaire