Bosch GKS 190 Instructions d'exploitation télécharger pdf (Page 10)

English - 5

The numbering of the tool elements refers to the

representation of the tool on the graphics page.

While reading the operating instructions, unfold

the graphics page of the tool and leave it open.

1 On/Off switch

2 Lock-off button for On/Off switch

3 Spindle locking button

4 Cutting angle scale

5 Wing bolt for parallel guide

6 Wing bolt for cutting angle setting

7 Cutting mark, 45°

8 Cutting mark, 0°

9 Rip fence

10 Retracting blade guard

11 Footplate

12 Riving knife

13 Adjustment lever for retracting blade guard

14 Sawdust ejector

15 Blade guard

16 Drive spindle

17 Mounting flange

18 Saw blade*

19 Clamping flange

20 Clamping bolt with washer

21 Hex key

22 Auxiliary handle*

23 Screw for attachment of the

auxiliary handle*

24 Wing bolt for cutting depth setting

25 Wing bolt for cutting angle preselection

26 Riving knife attachment

27 Set of screw clamps**

* Not all of the illustrated or described accessories are

included as standard delivery.

** Commercially available (not included in the delivered

items)

The tool is intended for cutting wood lengthways

and crossways in straight lines and at bevel an-

gles of up to 45° on a firm surface.

■ Before any work on the tool itself, pull the

power plug.

Mounting the Auxiliary Handle

(see figure )

Mount the auxiliary handle 22 to the blade

guard 15 with the screw 23.

Checking the Adjustment of the

Riving Knife (see figure )

The adjustment is carried out at minimal cutting

depth, as described in the section “Adjusting the

Cutting Depth”.

It is best to place the tool on the face side of the

blade guard.

Loosen the screw 26, adjust the riving knife 12

and retighten the screw. Observe the values

given in the figure.

Disassembly/Assembly of the

Riving Knife

For disassembly of the riving knife 12, unscrew

the screw 26 and remove the riving knife.

For assembly, insert the riving knife 12 and

tighten it with the screw 26. Afterwards, check the

adjustment of the riving knife as described previ-

ously.

■ Before any work on the tool itself, pull the

power plug.

☞

To achieve an optimum cut, the saw blade

must not protrude the material by more

than 3 mm (maximum).

To adjust the depth of cut, loosen wing bolt 24

and raise the saw from the footplate 11 or lower

it towards the footplate, respectively:

Raise ➡ for smaller cutting depths

Lower ➡ for greater cutting depths

Retighten the winged screw 24.

Tool Elements

Intended Use

Before Use

Adjusting the Cutting Depth

(see figure )

1 609 929 H62.book Seite 5 Freitag, 20. Januar 2006 8:31 08

10 • 1 609 929 H62 • 06.01

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Commentaires sur ces manuels

Pas de commentaire

Bosch GKS 190 Instructions d'exploitation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Bosch GKS 190