Bosch ARD-AYH12 Manuel d'utilisateur télécharger pdf

Engineered Solutions | D9210B Series Access Control Interface Modules

D9210B Series Access Control Interface

Modules

www.boschsecurity.com

u Provides direct interface to 26‑bit Wiegand card

readers

u Onboard buzzer output

u Removable onboard relay for switching

12/24 VDC/VAC power

u Option to unlock or lock door upon SDI bus failure

u Supervised onboard point

The D9210B Access Control Interface Module Series

includes the D9210B and the D9210BLC. The modules

are fully supervised, addressable SDI bus devices that

allow access control integration for the Bosch Security

System, Inc. G Series Control Panels. These highly

reliable modules offer 14 programmable levels of

access authority. Authority for access is controlled by

the level of the user, the time of day, the state of the

door and the armed state of the area. Each of the

authority restrictions can be controlled through

automatic and manual functions. Users can be added

to the system with local programming using the

D5200, remote programming using the Remote

Programming Software, or with tokens using the Add

User function through the command center(s).

Functions

Inputs and Outputs

• SDI input and output: SDI A (yellow) receives data

from the SDI A of the panel. The SDI B (green)

returns data to the SDI B of the panel.

• The 12 VDC input: Powers the D9210B and provides a

connection for the 12 VDC reader and 12 VDC buzzer.

• A supervised zone input for the door contact is

physically mounted on the door to which the strike is

connected. The input can be configured for shorts/

opens on faults but is normal only when the 1000 kΩ

resistor is in the circuit.

• The unsupervised tamper input is normal when open.

Upon a short, the point number assigned to the

supervised zone is reported as a MISSING PT###

report.

• The unsupervised Request to Enter (RTE) and

Request to Exit (REX) inputs are Normally open and

share the same common terminal. The REX input

generates the Door Request to Exit and is used to exit

the area assigned to the D9210B without having to

use an ID. The RTE generates the Door Request to

Enter and is used to enter the area assigned to a

D9210B Series module. Programming REX Shunt Only

and RTE Shunt Only eliminates the need for a strike

and would be used in applications where a push bar

is used to open the door.

• The Wiegand reader input is a 5‑wire input that

supplies +5 VDC (use the +12 VDC terminal for 12‑volt

readers), negative, ground activation for the reader

LED, (D1) and (D0) inputs for the card data.

1 2 3 4

Résumé du contenu

Page 1 -

Engineered Solutions | D9210B Series Access Control Interface ModulesD9210B Series Access Control InterfaceModules www.boschsecurity.com

Page 2

• When a door is held open past the normal doorsequence time, an extended door sequence time isinitiated. This extended time extends the shunt andre-a

Page 3

Technical specificationsAlarm InputsDoor Contact Status 1 normally‑closedRequest to Enter (RTE) andRequest to Exit (REX)1 normally‑openV in < 1.8 V

Page 4

4 | D9210B Series Access Control Interface ModulesRepresented by:Americas: Europe, Middle East, Africa: Asia-Pacific: China: America Latina:Bosch Secu