Precision Engineered Opto-Electronics™ EX12LED Infrared LED Illuminator
5 FIGURE 1 – 2 Front View
6 FIGURE 1 – 3 Rear View
7 2. INPUT POWER CONNECTIONS – Reference Only The voltage operating range is 12~24AC/DC. Note: input leads are not polarity dependent. FIGUR
8 3. MOUNTING - ILLUMINATOR UNIT Select a suitable location that is protected from accidental damage, tampering, and environmental conditions exceed
9 Secure all cabling. Installations on drywall must use a ¼” bolt and drywall butterfly type anchor or superior connection. The EX12LED can b
10 Note: The Tilt Adjustment screws should be loosened only. Do not remove these screws. FIGURE 3 - 1 Mounting Details
11 4. LED ADJUSTMENTS Note: The current setting of LED is 0.9A by manufacturer default. End user not advisable for adjustment. For photocell “On/Off”
12 5. ILLUMINATOR UNIT RE-ASSEMBLY Make sure the input power wires are properly connected and tightened into the terminal block, all holes are seale
13 FIGURE 5 – 1 Rear Cover Re-Assembly
14 6. TROUBLESHOOTING GUIDE PROBLEM POSSIBLE SOLUTION Fuse Blows - Check fuse rating. - Check for shorting between the enclosure and the input
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep this instruction. 3. Heed all warnings. 4. Follow these instructions. 5.
15 PROBLEM POSSIBLE SOLUTION LEDs are not turning “OFF” when sufficient ambient light is present - Make sure the photo sensor is not covered
16 7. GENERAL SPECIFICATIONS LED Type... High Perf. 850nm / 940nm LED Beam Angles ... 60deg. (W), 30deg. (M) Operational Range...
17 Americas Bosch Security Systems, Inc. 850 Greenfield Road Lancaster, Pennsylvania 17601 USA Telephone+ 1 888-289-009
IMPORTANT For best results, please read this Instruction Booklet prior to installing the EX12LED Illuminator Unit. WARNING! CSA Certified / UL Lis
NOTE: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC rules. These limits ar
INDEX – EX12LED Page Description...1 Un
1 DESCRIPTION The EX12LED Infrared LED Illuminator provides night-time covert lighting for short range indoor and outdoor surveillance when used
2 UNPACKING Care should be taken when unpacking the shipped unit. Check the parts list and confirm all items have been located. Inspect the equipment
3 INITIAL PREPARATIONS The EX12LED operates in either Vdc or Vac mode. The power input supply voltages can be 12-24VAC/DC See Section 2, Input P
4 1. MECHANICAL SPECIFICATIONS (See Section 7 - General Specifications, for additional information) FIGURE 1 – 1 Outline Dimensions
Commentaires sur ces manuels