Bosch EX36 Manuel d'installation télécharger pdf (Page 12)

10 en | EX36-IP

MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems

2.) Attach the faceplate to the camera housing. Insert and tighten the

6 bolts.

3.) Power-up the camera and check its operation.

2.6 Camera re-assembly

Make sure all wires are properly connected, all holes are sealed

against moisture penetration, and all mounting screws are tight.

1.) Slide the lens foam over the camera lens. Make sure the foam is

snug and as close to the faceplate viewing window as possible

and the photocell is secure with an unobstructed view.

2.) Attach the faceplate to the camera housing. Insert and tighten the

6 bolts.

3.) Power-up the camera and check its operation.

Note: Use Infra-Red Pass filter to cover the lens during focusing to

simulate low light conditions on scene for correct 24-hour focusing.

For camera with manual iris lens, the camera should be focused with

the lens iris fully opened to simulate the worst possible depth of field.

Using a Infra-Red Pass filter will ensure the iris is fully open for

correct setup and adjustment.

Note that statement above is applicable only for Day/Night or IR

version cameras.

1 2 ... 7 8 9 10 11 12 13 14

Pas de commentaire

Bosch EX36 Manuel d'installation Page 12