EL-50600-7-2 | REV. B | 20.10.2013
Bosch Automotive Service Solutions LLC
Installation and Operating Instructions
|
Power Xpress Charge Station | 19
|
en
Operating Instructions
1. Verify service supply power is available; green POW-
ER indicator LED is illuminated.
2. Retrieve Charge Station vehicle cable and coupler
from rear-mounted holder (stowed position); amber
STATUS indicator light is illuminated.
3. Connect Charge Station coupler to vehicle; STATUS
indicator LED changes to solid green.
4. Charge Station performs safety self-test (audible
mechanical clicking sounds); STATUS indicator
begins to ash green, indicating vehicle is charging
(vehicle may indicate charging with an audible
signal or a light indicator; varies by vehicle model).
When charge is complete, the STATUS LED will
change from ashing green to solid green.
5. Disconnect Charge Station coupler from vehicle;
STATUS indicator changes to amber.
6. Return cable and coupler to rear-mounted holder
(stowed position) at Charge Station unit.
Note:
Charge Station will automatically resume charging upon
restoration of lost service-supply power (US models
only).
Power and Status LED Indications
Power LED Status LED Condition
(Off)
(Off)
No service supply
power
Green
solid
Amber solid
Charge Station
powered; vehicle
coupler not
connected
Green
solid
Green solid Waiting to charge
Green
solid
Green
ashing
Vehicle charging
Green
solid
1–2 red
ashes
every 2
seconds
Pilot charging
error*
Green
solid
Solid red,
then green
ash every
2 seconds
Ground fault
detected*
Green
solid
Red
ashing
Ground monitor
interrupted*
Green
solid
Red solid Operation fault*
Green
solid
(Off) Operation fault*
*See “Troubleshooting” on page 20 for suggested
solutions.
- No illumination
- Solid illumination
- Flashing illumination
Commentaires sur ces manuels