Bosch PLN‑24CH12 Spécifications télécharger pdf (Page 16)

16 en | Installation Battery Charger

180110011Aa | V1.1 | 2011.05 Installation and Operation manual Bosch Security Systems B.V.

5 Installation

Before installing the battery charger into the 19" rack, the battery jumper setting must be

carried out.

5.1 Battery jumper setting

The battery charger takes every 4 hours a resistance measurement (Ri) of the battery

including connections and battery fuse if the total output current (main plus auxiliary) is

<12 A.

For each battery charger type a jumper is located at the daughter board to set trigger

thresholds for the resistance and allowed discharge current.

Figure 5.1 Location of the battery jumper of the PLN-24CH12 (similar location for the PRS-48CH12)

The jumper is set on the ‘75’ position as factory setting. Any other position of the jumper is

equal to the ‘50’ position.

Exceeding the Ri thresholds is signalled as a battery fault (see section 3.4.1 ) and means that

the battery charger with its associated battery will not have the required back-up duration in

case of mains failure.

To avoid initiating this fault, take care of the following:

– Use authorized batteries (see Section 7 Configuration).

– Use short battery cables with a diameter as large as possible (35 mm² max.):

– For a cross-section of 10 mm², the resistance is 2 mΩ/m

– For a cross-section of 16 mm², the resistance is 1.25 mΩ/m

– For a cross-section of 25 mm², the resistance is 0.8 mΩ/m

– For a cross-section of 35 mm², the resistance is 0.6 mΩ/m.

– Example: for battery cables (+ and -) 1.5 m in length and with a cross-section of 10 mm²,

the resistance is 6 mΩ.

– The connections should be realized properly in order to generate as low resistance as

possible.

– An additional battery fuse will add about 1 to 2 mΩ.

Jumper setting Voltage Threshold (Ri) Battery capacity Max. allowed

discharge current

75 (factory default) 24 Vdc 13 mΩ±10% 86 to 225 Ah 150 A

48 Vdc 26mΩ±10% 86 to 225 Ah 150 A

50 24 Vdc 20mΩ±10% 65 to 225 Ah 100 A

48 Vdc 40mΩ±10% 65 to 225 Ah 100 A

100 75 50 25

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 34 35

Pas de commentaire

Bosch PLN‑24CH12 Spécifications Page 16