Bosch REG Sentry Access Control Manuel d'instructions Page 1

INST-164 Reg-SentryThe following instructions assume a good working knowledge of the windows operating system. If you are networking this unit, it is

INST-164 Revision 4 Page 10 of 18 9) The basic function of the Reg-Sentry is to compare captured licence plates with those stored on a list. To ent

INST-164 Revision 4 Page 11 of 18 Trouble ShootingNetwork SettingThe default Reg-Sentry IP address is 192.168.0.204. It is possible that this IP add

INST-164 Revision 4 Page 12 of 18 Select “Internet Protocol (TCP/IP)” and then click on the “Properties” button. Figure 13: Internet Protocol (TCP/IP

INST-164 Revision 4 Page 13 of 18 Figure 15:System Information Hyperlink Follow the change network settings hyperlink Figure 16: Change Network Set

INST-164 Revision 4 Page 14 of 18 Figure 17: Network Setting Page This page allows all the relevant network setting to be changed. Return to Default

INST-164 Revision 4 Page 15 of 18 LED Location and FunctionFigure 19: LED Location DSP 1, Lit when a video input is detected. The LED is orange in c

INST-164 Revision 4 Page 16 of 18 Figure 20: SentryViewer Interface Help Document

INST-164 Revision 4 Page 17 of 18 Figure 21: Settings Menu Help Document

INST-164 Revision 4 Page 18 of 18 This product complies with Electromagnetic Compatibility Directive meeting the following standards EN 61000-6-3: 20

INST-164 Revision 4 Page 2 of 18 Licence Plate Recognition Access Control System (REG-SENTRY)Installation InstructionsContents Page D

INST-164 Revision 4 Page 3 of 18 DescriptionThe Reg-Sentry is a self contained access controller that uses automatic licence plate recognition (ALPR

INST-164 Revision 4 Page 4 of 18 The maximum vertical view angle of an ALPR camera is 30 degrees. <30° The maximum horizontal view angle of an ALP

INST-164 Revision 4 Page 5 of 18 Cable ConnectionFigure 4: Stand Alone Configuration There are five cable glands present on the Reg-Sentry (see fig 4

INST-164 Revision 4 Page 6 of 18 Video Cable (BNC type Reg-Sentry) At the top of the box is the video cable entry point. A good quality 75G video ca

INST-164 Revision 4 Page 7 of 18 Commissioning To commission the Reg-Sentry you will need to connect the unit to a PC using the network connector on

INST-164 Revision 4 Page 8 of 18 6) Once connected, the password box will now appear in front of the viewer. Initially, the password is unset. Clic

INST-164 Revision 4 Page 9 of 18 8) The Settings menu has several functions and is activated by clicking on the “Settings” button, see fig 8. NB Pl